Are You Curious To Learn About Speakers for cars?

PANAMA (6-December-2016) Listen to music while driving is enjoyable. Instead of using an iPhone, you can consider an amplifier of installation connected to the speakers and an amazing effect of your car audio system that other people in your car can also get to listen to your favorite music. Therefore, in this article, we would like you to install an amplifier in your car to help. Better is to click here or visit our official website to know more about speakers for cars.

The first thing to consider is where you want to put the amplifier. It is best to place the amplifier on the passenger seat when you want to feed the main loudspeakers. For the wiring, buy a power cord bulk wire 3 meters from the earth in the same thickness as the power cord, a RCA signal 16-gauge cable to the main speaker with 12 feet per speaker to power and distance to a cable.

Now you need to prepare tools such as wire cutters, pliers, wire strippers, screwdrivers, sandpaper, knives and tape. As you feed the main loudspeaker, you must squeeze two woman in your car for each speaker connections sword. When you are ready, try to get a manual with instructions for removing the car dashboard. In fact, it is only necessary to remove the main unit, not the entire dashboard. You must connect the son in the back.

Now you can start the installation. You must ensure that everything is disconnected from electricity. This is for safety. Therefore, it is necessary to disconnect the negative battery cable. Take the fuse in the power cord red (positive) and connect it to the positive terminal of the battery. Then you can place the cable fuse in the fuse holder.

Now you can connect the power cord through the firewall of your car and amplifier. Just be careful where you want the cable to run. Place the power cord near the son or signal speaker. After that, you can connect a metal screw in its car near the amplifier to connect the mini-cable. Make sure the distance is less than 3 meters. Loosen the screw and wipe the surface with sandpaper. Then plug the floor with an O-ring. If so, tighten the screw.

Now plug the RCA connectors and the remote control on the back of the unit. Then you can put it all together. Finally, make some work to make sure that make everything check. If needed interested individuals can click here http://www.carspeakersnet.com/ or visit our official website in order to know about car sound systems.

Comments are closed.